Filter
Top Products
110
19
BASIC OPERATIONS ON CONTROL PANEL㩷
㩷
The following operation are possible through control panel:㩷
㩷
1. Setting the temperature䊶䊶䊶The chamber temperature can be set (page 20).
2. Setting the CO
2
density䊶䊶䊶The chamber CO
2
density can be set (page 20).
3. Setting the key lock䊶䊶䊶Changing the temperature and CO
2
density can be disabled (page 21).
4. Setting alarms䊶䊶䊶The temperature alarm, CO
2
density alarm (page 25), and upper limit alarm
temperature (page 24) can be set.
5. Setting UV parameters䊶䊶䊶ON/OFF parameters and the ON period of the UV lamp can be set for the
MCO-19AIC(UV) or when the Incubator is equipped with the optional MCO-19UVS (page 26).
6. Setting other parameters䊶䊶䊶The initial settings of the date, time, and log cycle (page 30), and the
LCD display and baud rate (page 32) can be set.
7. Displaying the operation log and transferring data䊶䊶䊶A graph of past operation data can be
displayed (page 33) and operation data can be transferred to a PC (page 34).
8. H
2
O
2
decontamination䊶䊶䊶H
2
O
2
decontamination of the chamber and internal attachments can be
performed when the optional H
2
O
2
Generator (MCO-HP) is installed (page 40).
9. Automatic CO
2
cylinder changeover䊶䊶䊶The cylinder can be switched when the optional automatic
CO
2
Cylinder Changeover System (MCO-21GC) is installed (page 57).
10. Setting the CO
2
standard gas density䊶䊶䊶The CO
2
standard gas density can be set when the
optional Automatic CO
2
Standard Gas Calibration Kit (MCO-SG) is installed. (page 59)
㩷