Samsung VCR8830T1R Vacuum Cleaner User Manual


 
42_ Troubleshooting
Troubleshooting
CHECKLIST BEFORE SVC CALLS
SYMPTOM CHECKLIST MEASURE TO TAKE
Robotic vacuum
cleaner cannot
find the charger.
Check whether the power
plug of the charger is plugged
correctly into the outlet.
If there are any obstacles within
a range of about 1m in front of
the charger and about 0.5m
range to the left and right of the
charger, you should remove the
obstacles.
If there are any foreign
substances on the change pin,
wipe them off with a dry towel.
Is the Smart gate installed
near the charger?
Move the Smart gate to another
place so that the robotic
vacuum cleaner can charge
automatically.
Is the distance detection
sensor of the Smart gate facing
the charger?
Change the direction of the
Smart gate or set the distance to
an appropriate value.
Robotic vacuum
cleaner passes
through the
Smart gate.
Are the batteries of the Smart
gate worn out?
Replace the batteries.
(2 type D (LR20) alkaline
batteries)
Is the Smart gate set to Guard
(virtual door) mode?
Set the Smart gate to Fence
(virtual wall) mode.
Is the Mode lamp turned off?
Check if the Smart gate is turned
off and then set the Smart gate
to a desired mode.
The battery
usage time of the
Smart gate is too
short.
Are you using manganese drycell
batteries?
Replace the batteries with new
alkaline batteries.
(2 type D (LR20) alkaline
batteries)
In the display
panel, From
30,29,28,…
the number is
counted down.
Is the robotic vacuum cleaner
forced to seperate from charger
or pressed during charging?
When the robotic vacuum
cleaner is seperated or pressed
during the charging, after
30-second counts it is returning
to the charger for recharging
automatically.
DJ68-00518A (EN-1)-0.1.indd 42 2009.11.5 11:35:37 AM