Open as PDF
Maintain tools and lter _39
Maintain tools and ﬁlter
04 MAINTAIN TOOLS AND FILTER
CLEANING THE ROBOTIC VACUUM CLEANER
CLEANING THE EDGE-CLEANING SIDE ROTATING BRUSH
2. Wearing rubber gloves, wrap the side rotating brush with
a cloth using hot water for about 10 seconds and wipe it
on the cloth.
Check whether the side rotating brush is bent or
whether there are any foreign substances stuck on the
You must turn off the Power Switch at the bottom of the
main unit before cleaning the robotic vacuum.
3. Turning the side rotating brush, repeat the procedures
in Step 2.
4. If hair or string is wrapped between the main unit
and the side rotating brush, undo the screw of the
side rotating brush using a (+) driver to remove it.
When reassembling the brush, check the “L” mark
on the edge-cleaning side rotating brush and the
“L” mark on the main unit and then reassemble the
side rotating brush.
Because the side rotating brush easily attracts hair and other foreign substances,
make sure to clean it frequently.
Excessive foreign substances on the side rotating brush can damage the brush.
DJ68-00518A (EN-1)-0.1.indd 39 2009.11.5 11:35:33 AM