Filter
Top Products
Alarm Setting
Alarm Enable OFF
Alarm Input
Alarm Out
Motion Detection
49
SPEED DOME CAMERA
48
SPEED DOME CAMERA
Camera setting
③
Alarm Out
Matches each alarm input to one of two Alarm Outs
·OUT1 SET/OUT2 SET
Matches two alarm outputs to one of four alarm inputs and MD.
·OUT1 TIME/OUT2 TIME
Sets the ON/OFF and operating time in units of seconds, minutes or hours for two alarm outputs.
(1~59 sec., 1~59 min., 1~59 hours)
·OUT1 OFF/OUT2 OFF
When each alarm output is activated, select this function to forcibly release the alarm outputs. The alarm
output is then deactivated.
Alarm Out
Alarm Output
OUT1 SET 1 2 3 4 MD
OUT1 SET 1 2 3 4 MD
OUT1 TIME OFF 01 Sec
OUT2 TIME OFF 01 Sec
OUT1 OFF
OUT2 OFF
Press the
Enter key
OUT1 SET
④
Motion Detection
Motion Detection sets the motion detection function, areas to detect motion, and sensitivity of motion
detection. With Motion Detection on, the movements of an intruder can be detected. When motion is detected,
an alarm signal is sent to the Alarm Out.
·MD Execute
With Motion Detection On, moves to the preset position and then to On.
·Detect Area
Sets the area to detect.
- Whole : Detects motion on the whole screen.
- Upper : Detects motion on the upper side of the screen
- Lower : Detects motion on the lower side of the screen
- Center : Detects motion on the center of the screen
·Sensitivity
Sets the detection sensitivity. The higher the number, the smaller the motion the sensor reacts to.
·Preset No
Sets the preset number to which to move a camera when motion is detected.
WHOLE UPPER
LOWER CENTER
Alarm Setting
Alarm Enable OFF
Alarm Input
Alarm Out
Motion Detection
Motion Detection
Motion Detection
MD Execute
Detect Area WHOLE
Sensitivity 12
Preset No ***
Press the
Enter key
MD Execute
ENGLISH