Filter
Top Products
8.5 Error status register
The HR 60 and HR 61 error status registers (holding register - 16-bit) are used to indicate con
-
troller or system errors. HR 60 contains general alarms, whereas special faults are entered in
HR 61. In modem mode (Co9 -> Fb01 = ON), the change in state of HR 60 or HR 61 causes the
controller to dial the control system.
In InF8 level the bits of the error status register are displayed:
4
FSR1 (general error):
The corresponding block at the top is set for every bit set
4
FSR2 (special error):
by pressing key, the set bits are displayed similar to FSr1
In both cases, the blocks 20 to 23 are visible when a bit is set in another error status register
(which is currently not visible) to make it immediately recognizable whether one of the maxi
-
mum 32 error flags has been set.
Holding register 60 (A set bit is indicated by on the right of number):
Number = Bit no. in HR 0 1234567891011
Bit value 2
0
2
1
2
2
2
3
2
4
2
5
2
6
2
7
2
8
2
9
2
10
2
11
Sensor breakage D0
Default values read D1
–D2
Mode switch RK1 faulty D3
Mode switch RK2 faulty D4
Mode switch RK3 faulty D5
Unauthorized access D6
Error alarm of a BE D7
WMZ error alarm issued to
meter bus
D8
WMZ error alarm issued D9
– D10
Fault alarm binary output
changed
D11
72 EB 5179 EN
Operational faults