Regency L676-1 Indoor Fireplace User Manual


 
Regency
®
L676-1 Direct Vent Gas Fireplace 43
MAINTENANCE
14) Unplug the green (TH) and white (TP/TH)
wires from the valve.
15) Disconnect the 2 DC Spark generator wires
from the DC spark box located in front of
the valve.
16) Disconnect the spark electrode wire from
the DC spark box.
DC Spark Box
DC Spark Box
17) Remove the 16 screws that hold the valve
tray to the rebox and slightly pull out the
valve tray.
Valve Tray
MAINTENANCE
18) Completely pull out the valve tray.
19) Replace the valve tray and reverse steps
to re-install.
20) Turn on the gas supply and check for gas
leaks.
21) Re-install the rear log stand.
22) Re-install the burner tube.
23) Re-install the grate.
24) Re-install the brick panels.
25) Re-install the burner o rice cover plate.
26) Re-install the log set.
27) Re-install the glass door.
28) Re-install the front cover plate
29) Re-install the mesh screen.
30) Check the inlet and outlet pressures.
31) Check operation of ame control.
32) Check for proper ame appearance.
11) Disconnect the inlet gas line from the
valve.
12) Undo the center wire clip on the side of the
rebox.
13) Unplug the wire harness that connects the
modulating coil to the receiver.