Filter
Top Products
C1492M-I (8/05) 9
Figure 5.
How to Install Cover
4. Remove the pan and tilt from the base of the Esprit System. Check the control wiring inside
the base of the unit.
NOTE:
To wire the connector for the controller, refer to the manual supplied with the American
Dynamics controller.
5. Reinstall the pan and tilt onto the base of the unit. Apply power to the system. The following
message is displayed on the monitor once the configuration cycle of the Esprit is completed:
TXB-AD Rev x.xx
NOTE:
x.xx represents the current firmware revision.
From AD Controller To 4-Wire Cable
B RX+ (Green wire)
W RX- (Red wire)
TOP GASKET
FRONT
RAIN
GUARD