Filter
Top Products
C1492M-I (8/05) 15
3. Set the J1 jumper on the TXB-AD to the proper termination setting. The TXB-AD is shipped
from the factory with the J1 jumper in the terminated position. To unterminate the unit,
remove the cover from the J1 jumper and then place the cover over one pin for storage. Refer
to Figure 13 and Figure 14.
Figure 13.
TXB-AD Translator Board Layout, Front and Back
Figure 14.
Receiver Location
16-PIN CONNECTOR
J1 JUMPER
BACK
DIP
SWITCH
FRONT
J1 TERMINATED
J1 UNTERMINATED
AMERICAN DYNAMICS
CONTROLLER
AMERICAN DYNAMICS
CONTROLLER
PTZ
PTZPTZPTZPTZPTZ
PTZ PTZ
PTZPTZPTZPTZ
LINE
1
LINE
1
LINE
2
LINE
3
LINE
4
LINE
5
LINE
2
LINE
3
LINE
4
LINE
5
RECEIVERS
EXAMPLE OF STAR CONFIGURATION WITH DAISY CHAIN
RECEIVERS
EXAMPLE OF DAISY-CHAIN CONFIGURATION
= TERMINATED = UNTERMINATED
LINES 1-5 MUST NOT TOTAL MORE THAN 4,000 FT (1,219 M)