Filter
Top Products
8 C1492M-I (8/05)
4. Install the TXB-AD translator by inserting the 16-pin connector located on the back of the
TXB-AD board into the mating connector on the Esprit system’s board. Refer to Figure 1 and
Figure 2.
5. Reinstall the nut and washer on the standoff to secure the translator board.
ESPRIT SYSTEM SETTINGS AND CONNECTIONS
1. Verify that all SW1 switches on the Esprit system are set to the OFF position.
For American Dynamics controllers with only 32 presets:
Set SW1-5 to the ON
position. Refer to Figure 1 for switch location.
2. Set the address for the Esprit positioning system. Refer to Table B and Table C in the
Appendix
for American Dynamics Camera Assignments and DIP switch settings. Refer to Figure 1 for
DIP switch location.
3. Reinstall the left cover on the pan and tilt. The cover must be properly seated and have a tight
seal all the way around when installed (refer to Figure 4). To reinstall the cover, do the
following:
a. Properly position the cover and slide it into place. The sides of the cover must fit under
the front and back rain guards of the pan and tilt, and the top of the cover must seat
against the lip of the top gasket.
b. Apply pressure and push the top of the cover down to align the screw holes (refer to
Figure 5).
c. Insert the Phillips screw and washer. Tighten until the screw will not turn.
Figure 4.
Proper Installation of Cover
NOT SEALED
THIS SIDE IS
IMPROPERLY
INSTALLED
THIS SIDE IS
PROPERLY
INSTALLED
GAP