Filter
Top Products
6 C1492M-I (8/05)
Esprit Integrated Positioning System Installation
The following items are supplied:
1 TXB-AD translator board (printed circuit board)
1 4-40 screw with lock washer (for Spectra II
®
Series only)
1 6-32 screw with lock washer (for Spectra III
™
Series only)
TXB-AD TRANSLATOR BOARD INSTALLATION AND SETTINGS
1. Turn off the power to the Esprit system. Refer to Figure 1 and do the following:
a. Remove the left cover on the pan and tilt.
b. Remove the shorting plug from the 16-pin connector located on the Esprit system’s
circuit board.
c. Remove the nut and washer from the standoff on the Esprit system’s circuit board.
NOTE:
Do not discard the 16-pin shorting plug. Save the plug in case the system ever is converted
back to a Pelco-controlled unit.
Figure 1.
Esprit System Pan and Tilt
PHILLIPS
SCREW
NYLON
WASHER
DIP SWITCHES
ON
OFF
ON
OFF
12345678
12345678
SW2 SW1
16-PIN
CONNECTER