Filter
Top Products
16 C1492M-I (8/05)
4. Install the TXB-AD board on the power module. Refer to Figure 15 and do the following:
a. Remove the shorting plug from the 16-pin connector on the ExSite system’s circuit
board.
NOTE:
Do not discard the 16-pin shorting plug. Save the plug in case the system ever is converted
back to a coax video system or a Pelco-controlled unit.
b. Insert the TXB-AD board into the 16-pin connector on the ExSite system’s circuit board.
Confirm that the TXB-AD board is fully seated into the 16-pin connector.
Figure 15.
TXB-AD Board Installation
16-PIN
CONNECTOR