Filter
Top Products
22 Chapter 1 Device Manager basics
214393-A
Table 1 Properties dialog box items
Area Item Description
Polling Status Interval Interval at which status information is gathered (default is 20
seconds).
(If Traps, Status
Interval: )
Interval at which statistics and status information are gathered
when traps are enabled. The default is 60.
Hotswap Poll Interval The interval at which Device Manager polls for module
information. The default is 1 interval.
Enable Enables (true) or disables (false) periodic polling of the device
for updated status. If polling is disabled, the chassis status is
updated only when you click Refresh on the Chassis tab.
SNMP Retry Count Number of times Device Manager sends the same polling
request if a response is not returned to Device Manager.
You may want to set this field to three or four.
Timeout Length of each retry of each polling waiting period. When you
access the device through a slow link, you may want to increase
the timeout interval and then change the Retransmission
Strategy to superlinear.
Trace The trace field is used to enable and disable SNMP tracing.
When Trace is selected, SNMP protocol data units (PDUs) are
displayed in the Device > Log dialog box.
Register for Traps When selected (enabled), automatically registers to received
traps when Device Manager is launched against a device.
Listen for Traps When selected (enabled), Device manager listens for traps from
the device
Max Traps in Log The specified number of traps that may exist in the trap log. The
default is 500.
Trap Port Specifies the UDP port that Device Manager will listen on to
receive SNMP traps.
Listen for Syslogs This feature is inactive and not available.
Confirm row deletion A dialog box displays when checked, before deleting a row.