Filter
Top Products
Chapter 6 NI-VXI Configuration Utility
©
National Instruments Corporation 6-19 VXI/VME-PCI8022 for Solaris
VXI/VME-MXI-2 Configuration Editor
Before running the VXI/VME-MXI-2 Configuration Editor, you
must run
resman.
Note: Throughout this section, the term VXI/VME-MXI-2 denotes that the
information applies equally to the VXI-MXI-2 or the VME-MXI-2.
Upon entering the VXI/VME-MXI-2 Configuration Editor, the
program displays a list of VXI/VME-MXI-2 boards that
resman
detected in your system, as shown in Figure 6-7.
Figure 6-7.
VXI/VME-MXI-2 Selection Dialog Box
Select the device you want to configure from the Detected Boards
pull-down list, or you can select User LA and type in the board’s logical
address in the Logical Address field. Click OK to enter the editor or
Cancel to return to the main menu.
After finding a VXI/VME-MXI-2, the VXI/VME-MXI-2
Configuration Editor displays a panel, as shown in Figure 6-8, that
you can use to modify its configuration settings. The panel displays the
current settings of the module. Notice that it also shows the hardware
revision and serial number of the VXI/VME-MXI-2.
The title of the screen will reflect the model of the device you have.
For instance, if you have a VXI-MXI-2, the title will read VXI-MXI-2
Configuration Editor as shown in the following screen.