National Instruments VME-PCI8022 Water System User Manual


 
Chapter 1 Introduction and Quick Start
VXI/VME-PCI8022 for Solaris 1-4
©
National Instruments Corporation
products using a single cable. Thus, MXI-2 lets CPU interface boards
such as the PCI-MXI-2 perform as though they were plugged directly
into the VXI/VME backplane.
In addition, MXI-2 boosts data throughput performance past previous-
generation MXIbus products by defining new high-performance
protocols. MXI-2 is a superset of MXI. All accesses initiated by MXI
devices will work with MXI-2 devices. However, MXI-2 defines
synchronous MXI block data transfers which surpass previous block
data throughput benchmarks. The new synchronous MXI block protocol
increases MXI-2 throughput to a maximum of 33 MB/s between two
MXI-2 devices. All National Instruments MXI-2 boards are capable of
initiating and responding to synchronous MXI block cycles.
Note: In the remainder of this manual, the term MXIbus refers to MXI-2.
Hardware Description
The PCI-MXI-2 is a half-size, PCI-compatible plug-in circuit board that
plugs into one of the expansion slots in your PCI-based computer. It
links your PCI-based computer directly to the MXIbus and vice versa.
Because the PCI-MXI-2 uses the same communication register set that
other VXIbus message-based devices use, other MXIbus devices view
the PCI-MXI-2 as a VXIbus device. The PCI-MXI-2 can also function
as the MXIbus System Controller and can terminate the MXIbus signals
directly on the PCI-MXI-2. In addition, you can have up to 16 MB of
onboard DRAM on the PCI-MXI-2 that can be shared with the MXIbus
and VXI/VMEbus and used as a dedicated data buffer.
The VXI-MXI-2 module is an extended-class, register-based VXIbus
device with optional VXIbus Slot 0 capability so that it can reside in any
slot in a C-size or D-size chassis.
Note: D-size VXI mainframes have connections for a P3 connector. The
VXI-MXI-2, however, does not have this connector and, if configured as a
Slot 0 controller, cannot provide the necessary control for VXI devices that
need P3 support.
The VXI-MXI-2 uses address mapping to convert MXIbus cycles into
VXIbus cycles and vice versa. By connecting to the PCI-MXI-2 board,
the VXI-MXI-2 links the PCI bus to the VXIbus. The VXI-MXI-2 can
automatically determine whether it is located in VXI Slot 0 and/or if it
is the MXIbus System Controller.