National Instruments VME-PCI8022 Water System User Manual


 
Chapter 1 Introduction and Quick Start
©
National Instruments Corporation 1-11 VXI/VME-PCI8022 for Solaris
PCI-MXI-2
This section summarizes the hardware and software default settings for
the PCI-MXI-2.
Table 1-1.
PCI-MXI-2 Hardware Default Settings
Hardware Component Default Setting
U17 Switch 1 (FOV) OFF: PCI-MXI-2 boots off the user-
configured half of the EEPROM.
U17 Switch 2 (TST) OFF: Factory configuration of the
EEPROM is protected.
U17 Switch 3 (POS) OFF: Do not alter this setting.
U17 Switch 4 (CT) ON: Do not alter this setting.
DRAM SIMM Installed Per customer order
Table 1-2.
PCI-MXI-2 Logical Address Configuration Editor Default Settings
Editor Field Default Setting
Logical Address 0
Device Type MBD
Address Space A16
VXI Shared RAM Size 0 KB
Shared RAM Pool 0 KB
Lower Half Window Byte Swapping Disabled (non-swapped)
Lower Half Window Memory Select System Memory
Upper Half Window Byte Swapping Disabled (non-swapped)
Upper Half Window Memory Select System Memory