National Instruments VME-PCI8022 Water System User Manual


 
Chapter 1 Introduction and Quick Start
VXI/VME-PCI8022 for Solaris 1-14
©
National Instruments Corporation
Configuration EEPROM
(U35 switches 3 and 4)
User-modifiable; factory settings
protected: both switches set to
NO.
DRAM SIMMs Installed Per customer order
SIMM Size Configuration (S6) OFF if SIMMS are 4 M x 32
or larger; ON if smaller than
4 M x 32.
Table 1-6. VME-MXI-2 Hardware Default Settings
Hardware Component Default Setting
A16 Base Address (U20) Hex C040
VME-MXI-2 Intermodule
Signaling (W2)
No user-defined pin selected
MXIbus Termination
(U21 switches 3 and 4)
Automatic MXIbus termination:
switch 3 OFF; switch 4 ignored.
Configuration EEPROM
(U21 switches 1 and 2)
User-modifiable; factory settings
protected: both switches OFF.
DRAM SIMMs Installed Per customer order
SIMM Size Configuration (S2) OFF if SIMMS are 4 M x 32 or
larger; ON if smaller than 4 M x 32.
Table 1-7. VXI/VME-MXI-2 Configuration Editor Default Settings
Editor Field Default Setting
Logical Address 1 (set by hardware switch)
LA Selection Set by hardware switch
Address Space A24 *
Table 1-5. VXI-MXI-2 Hardware Default Settings (Continued)
Hardware Component Default Setting