Filter
Top Products
26
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1. Place the rear log (A) as shown in Figure 42. Position the 2 holes
on the bottom of the log over the corresponding locating pins (#1 &
#2) and against the log support bracket. See
Figures 41 and 42 for
pin and rear bracket locations.
2. Place the left middle log (B) as shown in Figure 43. Position the hole
on the bottom of log B over the corresponding locating pin on Log A.
5. Place the right middle log (C) as shown in Figure 46
. Position log
C behind Log E and resting on the "flat" on Log A.
3. Place the left front log (D) as shown in Figure 44
. Position the hole
on the bottom of log D over pin# 3.
4. Place the right front log (E) as shown in Figure 45
. Position the hole
on the bottom of log E over pins #4 and # 5.
6. Ember Placement - Separate the Embers (rockwool) into pieces
about the size of a quarter (see
Figure 41). Keep the pieces fluffed
up, not matted. Distribute these pieces over the surface of the burner,
as shown in
Figure 47. Do not use more than is necessary. Ensure
that the main burner ports remain uncovered by the ember material
(see Figure 41).
A
Figure 42 - Install Rear Log (A)
B
A
Figure 43 - Install Left Middle Log (B)
Figure 46 - Install Right Middle Log (C)
Figure 44 - Install Left Front Log (D)
Figure 45 - Install Right Front Log (E)
1
2
Figure 47 - Ember Placement
DO NOT place ember material directly
over the ember burner ports.
3
4
5
D
3
D
C
E
A
E