Filter
Top Products
14
Conversion Kit (LPG #154391, NG # 154392)
Tools required:
• 1/4” nut driver
• 1/2” & 13 mm open end wrench or deep-well
socket
• Torx T20 or slotted screwdriver
• 7/16” open end wrench
• 3mm allen wrench
• 4 mm allen wrench
Conversion Kit Contents:
• 1 regulator tower labeled for propane
• 3 regulator tower screws
• 1 burner orifice (3.3 mm for NG, #48 for LP)
• 1 pilot orifice (#51 for NG, #30 for LP)
• Label A - to be completed and applied to the back
of the stove
• Label B - apply to the rating plate
• Small valve label - apply to valve body
• Conversion instructions
IN CANADA:
THE CONVERSION SHALL BE CARRIED
OUT IN ACCORDANCE WITH THE RE-
QUIREMENTS OF THE PROVINCIAL AU-
THORITIES HAVING JURISDICTION AND
IN ACCORDANCE WITH THE REQUIRE-
MENTS OF THE CAN1-B149.1 & .2 INSTAL-
LATION CODE.
Mobile Home Installation
The GF 600 DV Firelight can be installed for use in a
mobile home in the U.S. and Canada provided:
1. The stove is secured to the floor of the mobile
home. Use Jøtul Floor mounting kit #750304.
2. The stove is installed in accordance with Title 24
CFR, Part 3280- Manufactured Home Construc-
tion and Safety Standard, in the U.S. Comply with
CSA Z240.4, Gas Equipped Recreational Vehicles
and Mobile Housing, in Canada.
3. Always contact your local officials about installa-
tion restrictions and requirements in your area.
THIS APPLIANCE MAY BE INSTALLED AS AN
OEM INSTALLATION IN A MANUFACTURED
(MOBILE) HOME AND MUST BE INSTALLED IN
ACCORDANCE WITH THE MANUFACTURER’S
INSTRUCTIONS AND THE MANUFACTURED
HOME CONSTRUCTION AND SAFETY
STANDARD, TITLE 24 CFR, PART 3280,
STANDARD FOR MANUFACTURED HOME
INSTALLATION, ANSI/NCBCS A255.1 OR
STANDARD FOR CANADA, CSA Z240.4.
THIS APPLIANCE IS ONLY FOR USE WITH THE
TYPE OF GAS THAT IS INDICATED ON THE
STOVE’S RATING PLATE. AN LPG GAS
CONVERSION KIT IS PROVIDED WITH THE
GF 600 DV FIRELIGHT GAS STOVE.
THIS APPLIANCE MAY BE INSTALLED IN AN
AFTERMARKET PERMANENTLY LOCATED,
MANUFACTURED (MOBILE) HOME, WHERE NOT
PROHIBITED BY LOCAL CODE.
CET APPAREIL PEUT ETRE INSTALLE DANS UN
MAISON PREFABRIQUEE (MOBILE) DEJA
INSTALLEE A DEMEURE SI LES REGLEMENTS
LOCAUX LE PERMETTENT.
CET APPAREIL DOIT ETRE UTILISE
UNIQUEMENT AVEC LES TYPES DE GAS
INDIQUES SUR LA PLAQUE SIGNALETIQUE. NE
PAS L’UTILISER AVEC D’AUTRES GAS SAUF SI
UN KITDE CONVERSION CERTIFIE EST
INSTALLE.
Fuel Conversion
The GF 600 DV Firelight gas stove is shipped from
the factory equipped as a NATURAL GAS unit.
However, the stove is shipped with the necessary
gas conversion kit to convert the stove to burn
propane gas. These kits contain all the necessary
components needed to complete the task and
ensure safe operation, including labels that must be
affixed to the stove.
WARNING:
THE CONVERSION KIT IS TO BE INSTALLED BY
AN AUTHORIZED JØTUL SERVICE TECHNICIAN
IN ACCORDANCE WITH THE MANUFACTURER’S
INSTRUCTIONS AND ALL CODES AND
REQUIREMENTS OF THE AUTHORITY HAVING
JURISDICTION. FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY OR PROPERTY DAMAGE. THE
QUALIFIED AGENCY PERFORMING THIS WORK
ASSUMES RESPONSIBILITY FOR THIS
CONVERSION.