Filter
Top Products
16
Changing the needle
q Needle clamp screw
w Needle clamp
CAUTION
Always make sure to turn the power switch off and
disconnect the machine from power supply before
changing the needle.
z Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, and lowering the presser
foot. Loosen the needle clamp screw q by turning it
counterclockwise. Remove the needle from the needle
clamp w.
x Insert a new needle into the needle clamp w with the
flat side to the rear. When inserting the needle into the
needle clamp w, push it up as far as it goes. Tighten
the needle clamp screw q firmly by turning it clockwise.
c To see if the needle is good, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
zx
c
q
w