Filter
Top Products
15
Changing the presser foot
q Snap-on button (red button)
w Groove
e Pin
CAUTION:
Turn off the power switch before changing the foot. Always
use the proper foot for the selected pattern. The wrong foot
can cause the needle to break.
•To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button q on the back of the foot holder.
•To attach
Place the selected presser foot so that the pin e on the
foot lies just under the groove w on the foot holder. Lower
the presser bar to lock the foot into place.
To remove and attach the foot holder
q Thumb screw
w Foot holder
e Presser bar
•To remove
Remove the thumb screw q by turning it counterclockwise
with a screwdriver.
•To attach
Match the hole in the foot holder w with the threaded
hole in the presser bar e. Fit the thumb screw q into
the hole. Tighten the screw q by turning it clockwise with
a screwdriver.
q
w
e
w
q
e
Knee Lifter
The knee lifter is extremely helpful when sewing applique,
patchwork and quilting since it allows you to handle the
fabric while your knee controls the presser foot.
Match the ribs on the knee lifter with the notches in the knee
lifter socket and insert the knee lifter.
q Knee lifter
w Ribs
e Notches
Push the knee lifter with your knee to raise and lower the
presser foot.
NOTE:
Do not touch the knee lifter while sewing, otherwise the
fabric will not be fed smoothly.
e
w
q