Filter
Top Products
30
4
RECEIVE AND TRANSMIT
D Repeater operation
A repeater amplifies received signals and retransmits
them at a different frequency. When using a repeater,
the transmit frequency is shifted from the receive fre-
quency by an offset frequency. A repeater can be
accessed using split frequency operation with the
shift frequency set to the repeater’s offset frequency.
➀Set the offset frequency and turn ON the quick split
function in initial set mode in advance (p. 52).
•If the quick split function is turned OFF, both transmit
and receive must be set separately.
➁Push [MODE] one or more times to select FM
mode, then set the receive frequency.
➂Select a suitable tone frequency or the 1750 Hz
tone burst in quick set mode.
➥ Push [DISPLAY] for 2 sec., then push [MENU]
one or more times to select “Q4 RPTR TONE.”
•If FM mode has not been selected, this item does
not appear.
➥ Rotate the main dial to set a subaudible tone fre-
quency or the 1750 Hz tone burst function.
➥ Push [DISPLAY] to exit quick set mode.
➃Push [(F-1)SPL] for 2 sec. (in the M1 display) to
activate the split frequency function (duplex func-
tion) with the pre-selected offset.
•When a subaudible tone frequency (excepting 1750 Hz)
is selected in
➂, “FM-T” is selected simultaneously.
➄Push and hold [PTT] to transmit; release [PTT] to
receive.
•When a 1750 Hz tone burst is selected, push and hold
[
(F-3)TON] in the M4 display while pushing [PTT] to
send the 1750 Hz tone burst.
➅To check the repeater input frequency (direct sig-
nal from the other station), push and hold
[(F-3)XFC] in the M1 display.
➆To return to simplex operation, push [(F-1)SPL].
Each memory channel can store a tone frequency
(subaudible tones or a tone burst) and an offset fre-
quency, as well as the operating frequency. Store
repeater information into memory channels for quick
and easy access to repeaters.
PROGRAMMING DUPLEX SHIFT FREQUENCY
➀Push [POWER] to turn power OFF.
➁While pushing [LOCK], push [POWER] to turn
power ON and enter initial set mode.
➂Select “DUP 144M” using [MENU] or the
[UP]/[DN] keys, then rotate the main dial to select
the desired duplex offset.
•The duplex offset can be selected from –4000 kHz to
+4000 kHz.
12
QUICK SPLIT
Turn the quick split
function ON.
(Initial set mode default
is ON.)
Q6
RPTR TONE
Set the tone frequency
(quick set mode).
See p. 49 for setting de-
tails and available fre-
quencies.
FM T
SPL
CH
VFO A
S1
5379204060dB
FM T
M4 VOX DUP TON
PO 5
10
CONVENIENT
17 DUP 144M