Filter
Top Products
26
4
RECEIVE AND TRANSMIT
D Speech compressor
The IC-706MKIIG has a built-in, low distortion
speech compressor circuit. This circuit increases
your average talk power in SSB mode and is espe-
cially useful for DX’ing when the receiving station is
having difficulty copying your signal.
➀Select USB or LSB mode.
➁Select the ALC meter.
•Push [DISPLAY] 1 or 2 times to select M, if necessary.
•Push [MENU] one or more times to select
M3, then
push [
(F-3)MET] one or more times to select “ALC.”
➂Select the mic gain display in quick set mode.
•Push [DISPLAY] for 2 sec.
•Push [MENU] one or more times to select
Q2 MIC
GAIN
.
➃Adjust the mic gain.
•While transmitting at your normal voice level, the ALC
meter should read at about the middle of the ALC zone.
•Be sure the mic gain is in the range of 2 to 5.
➄Select M4.
•Push [DISPLAY] 1 or 2 times to select M, if necessary.
•Push [MENU] one or more times to select
M4.
➅Push [(F-2)COM], then adjust [COMP GAIN] so that
the ALC meter reads within the ALC zone whether
you speak softly or loudly.
Note:When the ALC meter peaks above the ALC
zone, your transmitted voice may be distorted.
[MENU] [(F-2)COM]
[COMP GAIN]
COMP
GAIN /SIDE T
BEEP
ALC
Adjust [COMP GAIN] so that the ALC meter
reads within the ALC zone.
ALC zone
D VOX operation
The VOX (Voice-operated Transmission) function
toggles between transmit and receive with your
voice. This function provides an opportunity to input
log entries into your computer, etc., while operating.
➀Select M4, then turn the VOX function ON.
•Push [DISPLAY] 1 or 2 times when S or G appears.
•Push [MENU] one or more times to select
M4.
•Push [
(F-1)VOX] to turn the function ON.
➁Select VOX GAIN in quick set mode.
•Push [DISPLAY] for 2 sec. then push [MENU] one or
more times to select
Q4.
➂While speaking into the microphone, adjust [VOX
GAIN] until the transceiver is transmitting.
➃Select VOX DELAY in quick set mode.
•Push [MENU] one or more times to select Q3.
➄While speaking into the microphone, adjust [VOX
DELAY] as desired.
➅Select ANTI VOX in quick set mode.
•Push [MENU] one or more times to select Q5.
➆If the receive audio from the speaker toggles the
transceiver to transmit during receive, adjust the
[ANTI-VOX] to the point where it has no effect.
➇Push [DISPLAY] to exit quick set mode.
[MENU] [(F-1)VOX]
[DISPLAY]
main dial