Filter
Top Products
SECUR1l’Y CODES
To Assign, Change,
or Delete
User Codes
Voice Module
1. Enter your Master code and press the CODE key,
2. Enter single-digit User Number for whom a code is to be assigned, changed,
or deleted.
3. If assigning or changing a user’s code, enter the desired 4-digit code
for use by that User Number. The console will beep once.
/f deleting a user’s code, perform steps 1 and 2 and then stop. In a few
moments the console will beep once, indicating that the existing code has
been deleted.
Important:
● Instruct other users to enter their codes carefully to avoid accidentally
entering the Duress code. If desired, other users can be assigned a code
ending in “9”, to prevent accidental Duress code entry.
. Temporary users should not be shown how to use any system function they
do not need to know (e.g., bypassing protection zones).
● Be sure user codes do not conflict with any Duress code.
If your system includes a voice module it will permit you to access the system via
a Touch-tone phone, either on-premises or by call-in when away. You can:
● Receive voice messages over the phone regarding system status.
. Arm and disarm the system and perform most function commands.
Complete information regarding the use of this feature is provided in a separate
manual: Phone Access User’s Guide that accompanies the voice module.
Notes:
. To turn off an alarm (with any system), enter: Security Code + [l/OFF] key.
● The “CALL-IN TAMPER” (“Cl”) console display and logic described in the
guide is not present in your system.
● The Relay Command Mode described in the guide is not active with your
system, but output relay actions may stillbe controlled if installer-programmed.
-11-