Heatiator BIR42 Indoor Fireplace User Manual


 
27
Figure 8.4 Assembling Chimney Sections
• Supportthepipeduringconstructionandchecktobesure
inadvertentloadinghasnotdislodgedthechimneysection
fromthereplaceoratanychimneyjoint.
• Attachastraightchimneysectionoranoffsettothetop
ofthereplace.
• Placeinneruetotheinsideofthechimneysectionbelow
it.Placetheoutercasingoutsidetheoutercasingofthe
chimneysectionbelowit.RefertoFigure8.4.
NOTICE: Chimney sections cannot be disassembled once
locked together. Plan ahead!
• Lockchimneysectionsand/oroffsets/returnstogetherby
pushingdownwarduntilthetopsectionmeetsthestop
beadonthelowersection.
• Pullonthetopsectiontomakesureitisfullyengaged
andwillnotseparate.
• Youmayuse#6or#8sheetmetalscrewsnolongerthan
1/2in.(13mm)tofastenchimneysectionstogether.Do
NOTpenetrateinnerue.
WARNING! Risk of Fire! You MUST use screws (pro-
vided) to fasten offset/returns to chimney sections to
keep the chimney parts from twisting. Failure to do so
could cause re.
• Fastenoffset/returnsto chimneysections. Insert the
screws(provided)throughthepredrilledholes.DoNOT
penetrateinnerue.
• Securechimney returnswithhanger straps(provided);
fastentostudsorjoists.
• Verticalstraightrunsofchimneymustbesupportedevery
35ft(10.7m).
C. Assemble Chimney Sections
WARNING! Risk of Fire! DO NOT install substitute or dam-
aged chimney components.
Use only those components described in this manual.
Substitute or damaged chimney components could impair
safe operation and cause overheating and re.
Heatilator•BirminghamBIR42•4059-308RevJ•1/11