Hearth and Home Technologies DV3732SBI Indoor Fireplace User Manual


  Open as PDF
of 77
 
Hearth & Home Technologies • DV3732SBI, DV3732SBIL • 2215-900 Rev. F • 9/1262
LATCHES
(BOTHBOTTOM
ANDTOP)
GLASS
ASSEMBLY
J. AirShutterSetting
Air shutter settings should be adjusted by a qualied in-
staller at the time of installation. The air shutter is set at
the factory for minimum vertical vent run. Adjust air shut-
ter for longer vertical runs.
NOTICE: If sooting occurs, provide more air by opening
the air shutter.
Figure14.5FixedGlassAssembly
G. FixedGlassAssembly
RemovingFixedGlassAssembly
WARNING! Risk of Asphyxiation! Handle xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
RemovingFixedGlassAssembly
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass door from the appli-
ance. See Figure 14.5.
ReplacingFixedGlassAssembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove
on the glass frame.
AirShutterSettings
H. InstallLouversandTrim
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to
model).
I. InstallHood
See Figure 14.6.
Models NG LP
DV3732SBI
DV3732SBIL
1/8 in. 1/2 in.
HOOD CLIPS LOCATED ABOVE GLASS FRAME.
SEE DETAIL A.
DETAIL A
Figure14.6InstallHood
 previous next