Hearth and Home Technologies DV3732SBI Indoor Fireplace User Manual


  Open as PDF
of 77
 
39
Hearth & Home Technologies • DV3732SBI, DV3732SBIL • 2215-900 Rev. F • 9/12
9
AppliancePreparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
A. TopVent
Figure9.2Rotate the top heat shield to the vertical
position as shown above. The heat shield must remain in
the vertical position.
Figure9.4Remove the seal cap.
Figure9.5 Remove the insulation basket and white insula-
tion from the center vent pipe.
Figure9.1 For top vent, remove the two screws holding the
top heat shield in place. For rear vent, see Section 9.B.
Note: Actual unit may look different than the replace shown
in this section.
2SCREWS
2SCREWS
Figure9.3Replace the two screws as shown.
Figure9.6Remove the insulation from the outer vent pipe.
WARNING! Risk of Fire! Do not remove heat shield. El-
evated header temperatures may cause a re.
 previous next