Hearth and Home Technologies DV3732SBI Indoor Fireplace User Manual


  Open as PDF
of 77
 
57
Hearth & Home Technologies • DV3732SBI, DV3732SBIL • 2215-900 Rev. F • 9/12
D. Doors
Only doors certied for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and nishing material is going to be used on the replace,
you may use the table below which shows the door mod-
els and the nishing material thickness allowed. For an
inside t there is an available template to assist with siz-
ing the nishing material.
UNITSAND
TEMPLATEPART#
DV3732SBI,DV3732SBIL(550-Template)
DOOR FIT
FINISHMATERIAL
THICKNESS
SEE
FIGURE
X Y
Aero-32 Inside 4 inches Max. 13.17 N/A N/A
Chad-32E Overlap 1 inch Max. 13.18 N/A N/A
Chad-32E Inside 1-4 inches 13.19 32-3/8 in. 30-3/8 in.
Halston-32E Overlap 1 inch Max. 13.18 N/A N/A
Halston-32E Inside 1-4 inches 13.20 32-3/8 in. 30-3/8 in.
Stop nishing material ush with replace surround opening.
X
(Includes 1/8 in. opening each side of door)
Y
X
(Includes 1/8 in. opening each side of door)
Y
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
DOOR
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
DOOR
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
DOOR
FRONT FACE OF FIREPLACE
FINISHING
MATERIAL
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
DOORS
Figure13.17AeroDoor
Figure13.19InsideFitDoor(Chad)
Figure13.20OperableHingeDoor(Halston)
Finishing material between 1 and 4 inches thick.
Refer to Table 1 for X and Y dimensions.
Figure13.18OverlapFitDoor(ChadandHalston)
Finishing materials 1 inch maximum thick.
Stop nishing material ush with opening.
Finishing material between 1 and 4 inches thick.
Refer to Table 1 for X and Y dimensions.
 previous next