Hearth and Home Technologies DV3732SBI Indoor Fireplace User Manual


  Open as PDF
of 77
 
Hearth & Home Technologies • DV3732SBI, DV3732SBIL • 2215-900 Rev. F • 9/1240
B. RearVent
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Figure9.8Fold the tabs toward the center of the re plug
(90º) and remove the insulation gasket.
Figure9.9Cut the metal retaining band and fold the
sides out.
Figure9.10Fold the center parts of the retaining band
out and use to remove the seal cap.
Figure9.11Discard the seal cap, remove and discard
the insulation basket. Note: Once the seal cap has been
removed it CANNOT be reattached.
Figure9.12Attach the rst vent section (it will snap into
place). Slide the insulation gasket onto the vent section,
up against the appliance and over the tabs. Use two self-
tapping screws to secure gasket to outer wrap.
Figure9.7To attach the rst section of vent pipe, make
sure to use the berglass gasket to seal between the rst
vent component and the outer replace wrap. Use 2 self
tapping screws to secure the gasket to the outer wrap.
Note: Once the seal cap has been removed, it cannot be
reattached.
2SCREWS
 previous next