Filter
Top Products
-
30
-
Digital display
In program mode: Shows
function codes and data
codes.
In Operation mode:
Shows the output fre-
quency and output current,
etc.
In Trip mode: Shows a
code indicating the
causes of the trip.
!
WARNING
1. The STOP key is valid only when the function has been set.
Assign another switch to emergency stops,
otherwise accidents could occur.
2. Operation starts suddenly if alarm reset is done with an running signal
input. Check that no running signal is input before alarm reset,
otherwise accidents could occur.
!
CAUTION
1. Do not touch the heat sink,
otherwise burns could occur.
4 Keypad Panel
4-1 Names and Functions
Program (Reset) key
Switches between Opera-
tion mode and Program
mode.
In Trip mode: Resets the
trip status and change to
Operation mode.
Function/Data key
In Operation mode: Switches
between frequency display and
output current display
during
stopped and running.
In Program
mode: Used to read and write
various function codes and func-
tion data items.
Up/down keys
In Operation mode:
Used to increase and
reduce the frequency
(motor speed).In Pro-
gram mode: Used to
change a function code
and data value.
RUN key
This key is used to start opera-
tion.
The LED is on during operation.
This key does not function when
the data code from the external
signal (digital input) is selected
(F02 = 1~4).
STOP key
This key is used to stop op-
eration.
T
his key does not function
when the data code from the
external signal (digital input)
is selected (F02 = 2 or 4).
I
I
I
I
I
I
FUNC
DATA
RUN
STOP
P R G
RESET