Filter
Top Products
5
920-198-01
*
A Friedrich RC1 wireless remote control can be used to operate all
QuietMaster
®
Programmable models.
Figure 4
To start unit
1
POWER -Pressthe Power buttononce.The unitwill automatically
turn on in the mode and fan speed it was last left on.
To set mode of operation
2
COOL -Pressthe Cool button toautomaticallyswitchthe operating
mode to COOL.
3
FANONLY-Pressthe FanOnly button if youwant to run the fanonly.
You may want to use this feature in conjunction with the Fresh Air/
Exhaust if you want tobring outside air into the room, or exhaust stale
air.(TheFRESHAIR/EXHAUSTfeatureislocatedonthefrontofthe
airconditionernearthetop.SeeFigure9onpage7.)
4
MoneySaver
®
- Press the MoneySaver
®
button to activate the
MoneySaver
®
feature. This cycles the fan with the compressor so
that the fan does not run all the time.
To adjust temperature
5
COOLER - Press the Cooler button to raise the temperature
setting.
6
WARMER - Press the Warmer button to lower the temperature
setting.
To adjust fan speed
7
FAN SPEED -PresstheFan Speed button to see the current set-
ting. Press again to change the fan speed. F1 is the lowest setting
(SLEEP SETTING), F2 is low speed (LOW), F3 is medium (MED),
and F4 is high (HIGH).
To set the hour clock
8
SETHOURCLOCK-PressSetHouronceto seethe currentclock set-
ting. Continue pressing the button until you arrive at the current time.
MAKESUREYOUSETTHEA.M.ANDP.M.PROPERLY.(NOTE:
MINUTESARENOTSHOWNON THEDI
SPLAY.) Alight will appearin
the upper left corner of the display when the hour is P.M.
How to use the remote control
*
(QuietMaster Programmable)
To set the timer
NOTE: Set the hour clock before attempting to set timer functions. You
cansetthetimerOn/Off a minimum of one hour apart, and a maximum
of 23 hours apart.
9
TIMER START -Press Start toview the current start time for cool-
ing. Continue pressing the Start button until you arrive at the start
time you desire. The start time for cooling will then be set.
10
TIMER STOP -PresstheStop button.Continue pressing the Stop
button until you arrive atthe stoptime you desire. The stoptime for
cooling will then be set.
11
TIMERON/OFF-PresstheOn/offbuttononce to activate(light on)
or deactivate (light off) the timer. Once the Start and Stop times
havebeen selected, theywill remaininmemory,and cycle dailyuntil
changed.
NOTE: Iftheunitis unpluggedorthe powerisinterrupted,theHOUR
CLOCK must be reset or the Tim
er On/off functions will not work.
Money
Fan
Timer Operation
Set Hr.
Stop
Start
Temperature
Fan
Cool
On/Off
Power
Cooler
Only Speed Saver
®
Warmer
8
10
7
11
9
43
1
2
56