Filter
Top Products
13
920-198-01
STEP 11 INSTALL THE SIDE WINGBOARD PANELS – Be sure the
-tuoehttahtdnalliswod niwehtotderucesneebsahtenibac
side support brackets have been installed as shownin Figure
D. Raise the window sash and install the right and left side
wingboard panels. (See Figure G).
STEP 12 INSTALL THE WINDOW SEALING GASKETS – Measure
andcutthevinylwindowsealgasket(greycolor,Item# 12)to
¿t the width of the window, and install as shown in
Figure H.
Pull the window sash down behind the gasket. Measure and
cut the dark foam window seal gasket (Item #13) and install it
between the upper glass panel and the top part of the lower
sash. (See Figure H).
NOTE: FOR REASONS OF SECURITY AND SAFETY, THE
GNI TNEV ERPFOSNAEMAEDIV ORPTSUMREMOT
SUC
THE WINDOW FROM OPENING.
TOP OF CABINET
PLACE WINGBOARD PANEL IN
WINDOW JAM TO COMPRESS THE
SPRINGS INSIDE THE RUNNERS,
AND SWING THE PANEL INTO PLACE
INDICATED BY THE DOTTED LINE.
WINDOW JAM
SECURE THE SIDE WINGBOARD PANELS TO
THE SIDE ANGLES WITH FOUR (4) #8 x ½" LONG
SCREWS (ITEM #11), TWO ON EACH SIDE.
SECTION A - A
Figure G
STEP 13 When possible, caulk the outside of the installation with
.skaelre htaewtneverpotgnikluacepytlairtsudni
STEP 14 INSTALL CHASSIS – After installing the shell, slide the chassis
into the shell stopping approximately 3" from full insertion. Stuff
the chassisseal gasketone inch deep between thechassis
and the shell (see FigureI). Begin at either bottom corner and
go up the side, across thetop, and downthe oppositeside. Then
pushthechassisallthew
ayintotheshellfortheremainingdistance
so that the plastic front meets the front edge of the shell.
If chassis seal gasket isnot installed, the operation of the unit
will be negatively affected. Operational noise and outside
noise will also be ampli¿ed.
STEP 15 Reattach the chassis retainer wire with the same screw as in
Step 3 (See Figure A).
Figure H
TOP WINGBOARD ANGLE
LOWER WINDOW SASH
VINYL
WINDOW
GASKET
INSERT VINYL WINDOW SEAL
GASKET OVER TOP ANGLE
TO WINGBOARD (ITEM #12)
INSERT FOAM WINDOW
SEAL GASKET (ITEM # 13)
SECTION B - B
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit.
Failure to do so can result in minor
to moderate personal injury.
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
CAUTION