Filter
Top Products
10
920-198-01
Standard Sash Window Installations
STEP 1 Remove decorative plastic return air grille to a safe area away
from unit. The return air grille can be removed by pulling at the
sides on either the top or bottom.
STEP 2 Also remove theinstallation hardware toa safearea away from
the unit.
STEP 3 wercsthgirrafehtgni vom erybreniatersissahcehtevomeR
in the basepan (see Figure A); save this screw to reattach
the chassis retainer after installation (S
tep 15). Also, remove
and discard the two retainer screws and black plastic washers
located at the rear of the unit.
STEP 4 tallupdnahehtesu,yra noit atstenibacehtsdlohtnatsissanaelihW
thefrontofthe basepan,together withthe pullstrap(seeFigureA)
topullthechassisoutofthecabinet.REMOVETHELARGEWHITE
ROS SERP MOCEHTNIARTSEROTDESUSKCOLBMAOF
DURINGSHIPMENT.Inspectbasepanfordislodgedwhiteblocks,
and r
emove. Do not remove any other foam parts.
STEP 5 Anchor the side angles (Item #6) by engaging the tabs at each
end of the sill plate (see Figure B) with the bottom loops of the
side angle. Engage the tabs at each end of the top angle (Item
#5) with the top loops of the side angle (see Figure B). Install
two(2)screws(Item#7)tosecurethetopangletabsandthe
side angle to the cabinet (see Figure B).
STEP 6 Check the window sill and frame to be sure they are in good
condition and ¿rmly anchored to the wall. Repair if necessary.
STEP 7 CABINET MOUNTING –Raisethelowersashwindow¼"
more than the height of the cabinet. Carefully slide the cabinet
through the openwindowuntil the sillplate channelrestsbehind
the window sill and the top support rests against the window
(see Figure C.) Center side to side and drill three (3)
5
»
32
" dia.
pilot holes intothe window sillusing the holes inthe cabinet sill
plate as a guide. Install three (3) #12A x 2" long screws (Item
#4,
Figure C).
HAND PULL
FAR RIGHT
SCREW
CHASSIS
RETAINER
WIRE
PULL STRAP
Figure A
Figure B
CABINET
TOPANGLE (ITEM #5)
SIDEANGLE
(ITEM #6) 2
REQUIRED
8Ax
" LONG SCREW
(ITEM #7) 2 REQUIRED
TAB
LOOP
SILL
PLATE TAB
DETAIL B-1
DETAIL B-2
Falling Object Hazard
Not following Installation Instructions
for mounting your air conditioner can
result in property damage, injury, or
death.
WARNING
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit.
Failure to do so can result in minor
to moderate personal injury.
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
CAUTION