Filter
Top Products
17
920-198-01
Figure F TYPICAL INSTALLATION
SILL PLATE GUIDE CHANNEL
INSIDE WALL SURFACE
CAULK ALL SIDES WEATHER TIGHT
SCREW #12A x 2"
LONG (USE 3)
TRIM MOULDING
STEP 6 Slide the cabinet into the hole far enough to allow the guide-
eeS(ecafrusllawedisniehttcat nocotetalpllisehtfolennahc
Figure F).
STEP 7 Drill three (3)
5
»
32
" dia. pilot holes through holes in sill-plate
into framing andinstall three (3) #12A x 2" long screws (See
Figure F).
NOTE:ALTERNATEFASTENERSWHICH MAYBEUS
EDFOR
SECURINGTHESILLPLATEINTHEWALLANDTHESUPPORT
BRACKETS TO THE OUTSIDE WALL (NOT FURNISHED BUT
AVAILABLE AT LOCAL HARDWARE STORE).
STEP 8 Drilltwo(2)
5
»
32
"dia. pilotholeseachcabinet sideat the locations
shown (seeFigureF) and installfour (4) #12A x2" screws(Item
# 4, page 9). Provided that Step 5 (hole construction) provides
a sturdy mount with solid vertical studs, no support brackets
are required. The installation must su
pport the weight of the
unit plus an additional weight of 400 pounds on the rear of the
cabinet.
If support brackets areavailable, theycan certainly beused for
through-the-wall installations as shown in Figure F.
Ifthereliabilityofthewallisinquestion,awindowinstallationkitwhich
includes support brackets can be ordered(see Accessories).
STEP 9 Ifdesired, trim around the cabinet on the room side with a suitable
frame moulding furnished by the installer (see Figure F).
STEP 10 Completethe installationbyfollowingsteps13through18ofSASH
.41-31segap,SNOIT CURTS NINOITALLATSNIWODNIW
STEP 11 Refer to the OPERATION SECTION for instructions.
" SLOPE DOWN
NOTE: SUPPORT BRACKETS MAY BE OMITTED
FROM THROUGH-THE-WALL INSTALLATIONS IF THE
CABINET IS SECUREDAS FOLLOWS. DRILL 2 HOLES
IN EACH SIDE AND INSTALL 4 FASTENERS (2 EACH
SIDE). USE #12 x 2" SCREWS, TOGGLE BOLTS OR
EXPANSIONANCHOR BOLTS AS SHOWN IN STEP 7.
SUPPORT BRACKETS (AVAILABLE AS OPTION AL AC CES SORY)
SCREW #12 x 2" LONG, USE ONE EACH BRACKET.
DRILL
5
»
32
DIA. PILOT HOLES.
MOLLY OR TOGGLE BOLT
EXPANSION ANCHOR BOLT
CABINET
Instructions for mounting sleeve with
slope must be observed to prevent entry
of water into room.
NOTICE