Filter
Top Products
www.fmiproducts.com
116646-01J 25
7. Install right brick panel using the same
method described in step 5 for left brick
panel.
8. Replace deector shield using screws
removed in step 4.
9. Follow instructions below to install logs,
lava rock and ember material.
10. Close glass door, lock latches on top and
bottom of door and replace screen (see
steps 5 and 6 of Removing Glass Door,
page 24).
11. Close top and bottom louvers.
Figure 44 - Installing Side Brick Panels
Left Side
Brick Panel
FIREPLACE INSTALLATION
Continued
INSTALLING LOGS, LAVA ROCK
AND GLOWING EMBERS
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with replace.
Open louvers, remove screen, unlock door
latches and open glass door. See steps 1 and
2 of Removing Glass Door, page 24. Install
logs according to instructions for replace
model numbers.
1. Place log #1 (rear log) on top of grate.
Make sure notches in bottom of log t
over grate (see Figure 45).
2. Rest log #2 (large front log) on pins on
front part of grate (see Figure 46).
3. Place log #3 (crossover log) onto rear and
front logs. Make sure it is seated properly
on smooth surface on front log and on pin
on back log as shown in Figure 47.
4. Place log #4 (right log) on pin on right side of
front log as shown in Figure 48, page 26.
1
Figure 45 - Installing Log No. 1
2
Figure 46 - Installing Log No. 2
3
Figure 47 - Installing Log No. 3
5. Place log #5 (base log) onto front left part of
grate making sure notches t over prongs
of grate). See Figure 49, page 26.