Filter
Top Products
www.fmiproducts.com
124978-01B 5
PRODUCT FEATURES
ASSEMBLY
Figure 2 - Assembling Fireplace
Log
Screen
Burner Support
with Log
Locator Tabs
Branch
Support
Shoulder
Screw
This replace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room replaces. The ODS/pilot
shuts off the replace if there is not enough
fresh air.
This replace has a piezo ignitor. This sys-
tem requires no matches, batteries, or other
sources to light replace.
THERMOSTATIC HEAT CONTROL
This replace has a thermostat sensing bulb
and a control valve. The thermostat will auto-
matically modulate the heat output to maintain
a consistent room temperature. This results in
greater replace comfort. This can also result
in lower gas bills.
UNPACKING
1. Remove replace and hood from carton.
Log is wrapped and inside replace. Do
not remove at this time.
2. Remove all protective packaging applied
to replace for shipment.
3. Make sure your replace includes one
hardware packet.
4. Check replace for any shipping damage.
If heater is damaged call FMI PRODUCTS,
LLC at 1-866-328-4537. Please do not
return product to the store.
WARNING: Always have
-
-
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
1. Lift screen up and pull out to remove.
2. Cut two plastic straps to remove the log
from the rebox cavity.
3. An optional blower is available. See Ac-
cessories, page 29. Install optional blower
now. Follow installation instructions pro-
vided with blower.
4. Remove log packaging material and
discard packaging. Gently place log set
on burner support (see Figure 2). The log
should t at against top of burner sup-
port and log locator tabs t into the slots
under the log. Do not allow log to contact
ame. If ame contacts log, soot will be
created.
5. Reattach screen by placing the notches
in the screen frame over the shoulder
screws and pushing down.