FMI CGCFTNA Indoor Fireplace User Manual


 
www.fmiproducts.com
124978-01B10

WARNING: Maintain the
minimum clearances shown
 


You can recess rebox into the wall. You can
also position replace in the optional cabinet
or corner mantels. IMPORTANT: Only use
optional cabinet or corner mantels speci-
ed in this manual. Purchase the optional
mantel from your dealer (see Accessories,
page 29).
INSTALLATION
Continued
Figure 7 - Mounting Clearances As
Viewed From Front of Fireplace Shown
with Optional Mantel
Top Of
Mantel Can
Be Flush
With Wall
Left
Side
CEILING
Right
Side
36"
Minimum
6"
Minimum
From
Sides Of
Fireplace
Left
Side
CEILING
36"
Minimum
FLOOR
Right
Side
0” Minimum
To Top
Surface Of
Carpeting,
Tile Or Other
Combustible
Material
0" Minimum
To Top
Surface Of
Carpeting,
Tile Or Other
Combustible
Material
Figure 6 - Mounting Clearances As
Viewed From Front of Fireplace Shown
Built-In the Wall
Note: When installing replace directly on
carpeting, tile or other combustible material,
other than wood ooring, the replace shall be
installed on a metal or wood panel extending
the full width and depth of the replace.
CAUTION: If you install the

 

 

For convenience and efciency, install replace
where there is easy access for operation,
inspection, and service.
in coldest part of room.
An optional blower kit is available from your
dealer (see Accessories, page 29). If plan-
ning to use blower, locate replace near an
electrical outlet.

INSTALLATION
Built-in installation of this replace involves
installing replace into a framed-in enclosure.
This makes the front of replace ush with
wall. An optional trim kit accessory is available
(see Accessories, page 29). Trim will extend
past sides of replace approximately 1/2".
This will cover the rough edges of the wall
opening. If installing a built-in mantel above
the replace you must follow the clearances
shown in Figure 11, page 12. Follow the
instructions below to install the replace in
this manner.
Actual Framing
Height 26" 26
7
/8"
Front Width 26
3
/4" 26
7
/8"
Depth 9
1
/2" 10
1
/2"
Bottom 3/4" 3/4"
1. Frame in rough opening. Use dimensions
shown in Figure 8, page 11, for the rough
opening.
If installing in a corner, use dimensions
shown in Figure 9, page 11, for the rough
opening. The height is 26
7
/8" which is the
same as the wall opening above.