Filter
Top Products
Page 917375-6-0705
REAR VENT CONVERSION
Note: Discard insulation
& retainer when using
vertical venting off
VERTICAL VENTING
HORIZONTAL VENTING
FLUE INSULATION
INSULATION
RETAINER
INLET VENT COLLAR
INLET VENT COLLAR
FLUE OUTLET
COLLAR
FLUE COVER PLATE
(See note above)
INLET VENT
COVER PLATE
FLUE COVER PLATE
INLET VENT
COVER PLA
TE
Note: It is recommended that the
flue cover plate tab be pulled
outward prior to removal.
This will ensure that the plate
is not accidentally dropped
inside the rear air chamber.
Note: Discard insulation
& retainer when venting off
top of fireplace.
Converting flue take-off to rear venting
When switching out the flue and inlet vent collars to run
horizontally off the rear vent, the following steps must be taken.
1. Remove the inlet vent collar (8 screws) and flue collar (4
screws) from the top of the fireplace, and set to the side.
2. Remove the inlet cover plate and flue cover plate located on
the back of the fireplace. These will be used to close the top
flue and inlet openings.
3. Insert the insulation retainer bracket and insulation into the
top flue pipe before reinstalling the flue cover plate over the
top flue with 4 screws.
4. Reinstall the inlet cover plate over the top inlet opening with
4 screws. See illustration above..
5. Install the flue collar assembly to the rear flue with 4 screws.
6. Install the inlet vent collar to the rear of the fireplace with 8
screws.
7. This completes the conversion for a rear vent application.
Note: for top vented installations, the insulation and retainer
are to be removed from the flue pipe and discarded.
VENT SYSTEMS
The following vent systems are acceptable for use with
the DVP series fireplaces:
Simpson Duravent® GS 5" - 8"
American Metal Products 5" - 8"
Selkirk Direct-Temp® 5" - 8"
Empire Flexvent Kit(s) (Magnaflex) 5" - 8"