Filter
Top Products
Page 28 17375-6-0705
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts
specifically approved with this appliance may result in
property damage or personal injury.
Attention: Do not use Figure 48B or Figure 49 to order
logs. Refer to parts view on page 45 and parts list on page
46 to order logs and/or ember material for your appropriate
fireplace model.
LOG PLACEMENT (3 LOG SET)
Before you begin: If you are installing logs into the DVP42
or DVP48 model then this fireplace is supplied with a set of
three ceramic fiber logs. Do not handle these logs with your
bare hands. Always wear gloves to prevent skin irritation
from ceramic fibers. After handling logs, wash your hands
gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation
of this fireplace. Sooting and other problems may result if the
logs are not properly and firmly positioned in the fireplace.
Please refer to Figure 48A, Figure 48B, and Figure 49 and
corresponding WARNING, when completing the following
log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of
firebox
4. Place bottom log onto main burner. Align holes on
bottom log with (4) locator pins on burner.
5. Place rear log on rear log shelf. Place rear log so that the
locator holes align with the (2) locator tabs in the log
support shelf.
6. Place top branch onto flat area of rear log and over the
front of the bottom log.
7. Place decorative rock in front of grates and sides of main
burner.
ATTENTION: Do not place decorative rock on logs or
on burner. The decorative rock should only be placed
on the fireplace floor.
8. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front round
"blueflame" ports. Place the ember material (Rockwool
pieces) side by side. Do not stack more than one layer of
embers across the burner ports. See Figure 48A.
9. Replace glass door onto firebox.
10. Secure the two glass frame spring clamps at bottom of
firebox.
11. Align the tabs on top louver brackets with slots in front
posts to secure top louver.
12. Close bottom louver. Lift slightly to engage the end tabs
into the slots in fireplace sides to close louver panel.
TOP BRANCH
REAR LOG
BOTTOM
LOG
Figure 48B
Figure 48A
EMBER PLACEMENT
REAR
LOG LOCATOR TABS
BOTTOM LOG LOCATOR PINS
Figure 49