Filter
Top Products
CertainTeed Vinyl Siding Installation Guide
123
Push on the back button of the snap rivet to secure the clip to the
panel. Repeat over each locking tab area.
Place the heavier part of the cam clip up against the cam.
While applying pressure to the top panel, pull down on the
thinner end of the clip.
Installing the new panel
Slide the left side of the new panel into the side locking tabs.
To engage the right side tabs into the existing panel, flex the
panel out from the center. As you raise the new panel into
position, make sure the bottom lip of the panel engages the
locking tabs on the panel below.
Lift up the panel above the new panel far enough to place the
nails into the old nail holes.
Using your wonder bar or roof snake bar, drive the nails in by
placing the bar on the nail head and hitting the bar with a hammer.
Place the heavier part of the cam clip up against the cam. While
applying pressure to the top panel, pull down on the thinner end
of the clip. Make sure each cam clip engages the lip of the panel
above it. Keep pulling down on the cam cords until they break off.