Vermont Casting 2100 Indoor Fireplace User Manual


 
31
WinterWarm Fireplace Insert or System
2000941
Use drywall screws to fasten the wall covering to the
metal standoff and drywall stops at the cabinet. Drill
pilot holes through the wall covering material and one
thickness of the sheet metal with a #40 (.098”) drill bit.
Tape and fill holes and/or seams and decorate your
chase wall at this time.
11. Install the vent grilles.
Position the cast grilles over
the duct box openings, and mark for the four screw
holes in each. Using a 5/32” (4mm) bit, drill through the
drywall and duct box flanges, and install the grilles with
the Phillips flat head black oxide screws.
Once the vent grilles have been installed, you are ready
to complete the installation by installing the fire cham
-
ber and the front.
FP1126
Optional Blower
Optional
Blower
Elevated Base
Junction Box
FP1126
Fig. 47 Slide the elevated base platform into the cabinet until
it contacts the back panel.
FP1126
blower housing
5/24/01 djt
Flange attaches
to cabinet rear
wall
Cabinet Convection
Blower Housing
Flange
attaches to
base
Convectiion
Blower Power
Cord
Elevated Base
FP1127
Fig. 48 The cabinet convection blower in place behind the
base.