Filter
Top Products
1-36 Setting Up
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?
!
9 —
CONTENTS
Index
6
5
6
5
1
6
5
13.Slowly return the needle threader lever to its original
position. Check that the hook has pulled the thread
through the eye, then release the lever.
14.Pull the thread loop toward the back of the machine.
Note
Do not pull the thread too strongly, as you may bend the
needle.
CAUTION
The needle threader lever can only be used with home
sewing machine needles size 75/11-100/16. Check the
table on page 1-45 for appropriate needle and thread
combinations. Note that, if you are using transparent
nylon mono-filament thread, only needles in the range
of 90/14-100/16 can be used.
15.Pass the thread under the presser foot, and pull it about
100 mm (3 inch - 4 inch) toward the back of the ma-
chine.
1 100 mm (3 inch - 4 inch)
CAUTION
• If the threading is not successful, raise the presser foot
lever and start again from step 8, setting the thread in
the needle clamp thread guide.
• There are certain decorative threads that can not be
threaded using the needle threader lever. When using
these threads, set the thread behind the needle clamp
thread guide (step 8), then thread the eye of the nee-
dle manually. Make sure the main power switch is OFF
when threading the needle manually.