Filter
Top Products
5-4 Embroidery
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
?
!
9 —
CONTENTS
Index
1
2
1
2
1
Attaching Embroidery Foot “Q”
CAUTION
• Always turn off the main power switch when attaching a presser foot. You may acci-
dentally press the “Start/Stop” button, resulting in injury.
•
Be sure to use embroidery foot Q when doing embroidery. The needle may strike the
presser foot, causing the needle to bend or break and resulting in injury.
1. Press the “Needle Position” button to raise the needle,
and then turn off the power.
2. Raise the presser foot lever.
3. Push the black button on the presser foot holder and
remove the presser foot.
1 Presser foot holder
4. Use the included screwdriver to loosen the screw of
the presser foot holder, then remove the presser foot
holder.
5. Set embroidery foot “Q” on the presser foot bar so that
the arm of embroidery foot “Q” is in contact with the
back of the needle holder, then use the included screw-
driver to firmly tighten the screw.
CAUTION
Use the included screwdriver to firmly tighten the
screw of the presser foot holder. If the screw is
loose, the needle may strike the presser foot, re-
sulting in injury.