Filter
Top Products
LCD SCREEN
Getting Ready
23
1
General settings
a Select the needle stop position (the needle position when the machine is not operating) to be up or down. Select the
down position when using the pivot key.
b Select the operation of the “Needle Position - Stitch Placement” button from the following two sequences (see page
74).
Each press of the “Needle Position - Stitch Placement” button:
“ON” – raises the needle, stops it at a nearly lowered position, then lowers it
“OFF” – raises the needle, then lowers it
c Change the brightness of the Needle Area and Work Area Lights.
d Change the speaker volume.
e Change the shape of the pointer when a USB mouse is used (see page 25).
f Turn both the upper and bobbin thread sensor “ON” or “OFF”. If it is turned “OFF”, the machine can be used without
thread.
g Select the length of time until the screen saver appears. A setting between “OFF” (0) and “60” minutes can be set in
1-minute increments.
h Change the image of the screen saver (see page 25).
i Select the initial screen that is displayed when the machine is turned on (see page 28).
j Use when running an application.
k Change the display language (see page 29).
l Display the service count which is a reminder to take your machine in for regular servicing. (Contact your authorized
dealer for details.)
m Display the total number of stitches.
n The “No.” is the number for the embroidery and sewing machine.
o Display the program version. “Version 1” shows the program version of the LCD panel, “Version 2” shows the
program version of the machine.
a
d
e
f
b
c
g
i
j
k
h
CAUTION
• If “Upper and Bobbin Thread Sensor” is set to
“OFF”, remove the upper thread. If the
machine is used with the upper thread
threaded, the machine will not be able to
detect if the thread has become tangled.
Continuing to use the machine with tangled
thread may cause damage.
l
n
o
m
Memo
• The latest version of software is installed in your machine. Check with your local authorized Brother
dealer or at “http://solutions.brother.com” for available updates (see page 344).