Filter
Top Products
SEWING
Sewing Basics
Sewing S-7
S
1
Sewing Curves
Sew slowly while keeping the seam parallel with
the fabric edge as you guide the fabric around the
curve.
Changing Sewing Direction
Stop the machine. Leave the needle in the fabric,
and press the “Presser Foot Lifter” button to raise
the presser foot. Using the needle as a pivot, turn
the fabric so that you can sew in the new
direction. Press the “Presser Foot Lifter” button to
lower the presser foot and start sewing.
The pivot setting is useful when changing the
sewing direction. When the machine is stopped at
the corner of the fabric, the machine stops with the
needle in the fabric and the presser foot is
automatically raised so the fabric can easily be
rotated (“Pivoting” on page S-15).
■ Sewing a Seam Allowance of 0.5 cm
or Less
Baste the corner before sewing, and then, after
changing the sewing direction at the corner, pull the
basting thread toward the back while sewing.
a 5 mm (approx. 3/16 inch)
Sewing Heavyweight Fabrics
The sewing machine can sew fabrics up to 6 mm
(approx. 1/4 inch) thick. If the thickness of a seam
causes sewing to occur at an angle, help guide the
fabric by hand and sew on the downward slope.
+
Machine starts
sewing and then sews
reinforcement
stitches while holding
the “Reverse Stitch”
button.
Machine starts
sewing at the
beginning, then
completes the pattern
and sews
reinforcement
stitches at the end of
sewing.
+
Machine sews
reinforcement
stitches at the
beginning and sews
reinforcement
stitches when the
“Reverse Stitch”
button is touched.
Machine sews
reinforcement
stitches at the
beginning, then
completes the pattern
and sews
reinforcement
stitches at the end of
sewing.
“Reverse Stitch”
button
“Reinforcement
Stitch” button
CAUTION
• Do not forcefully push fabrics more than
6 mm (approx. 1/4 inch) thick through the
sewing machine. This may cause the needle to
break and cause injury.
• Thicker fabrics require a larger needle
(“CHANGING THE NEEDLE” of “Basic
operations”).