Filter
Top Products
USING SENSOR FUNCTIONS IN “EMBROIDERY”/“EMBROIDERY EDIT” MODE
Sensor Functions
Basic operations B-83
B
2
Before using the sensor functions, carefully read the procedure in “Embroidery” and “Embroidery Edit” to
familiarize yourself with the machine operations.
Specifying the Embroidering
Position With the Sensor Pen
By using the sensor pen, the embroidering position
can be adjusted to the desired location. This
function can be performed in either “Embroidery”
or “Embroidery Edit” mode, but the procedure
described below is performed in “Embroidery”
mode.
If the message “The carriage of the embroidery
unit will move. Keep your hands etc. away from
the carriage.” appears during the operation, ensure
safety, and then press .
a
Turn on the machine.
b
Press .
c
Select the category for the pattern to be
embroidered.
d
In the pattern selection screen, press the
key for the pattern to be embroidered.
e
Press .
f
Hoop the fabric and attach the embroidery
frame to the machine.
→ Refer to “Hooping the Fabric in the Embroidery
Frame” on page E-13 and “ATTACHING THE
EMBROIDERY FRAME” on page E-17.
g
Press .
→ Select the desired area and press when the
following message appears (only for use of the extra
large embroidery frame).
USING SENSOR FUNCTIONS IN
“EMBROIDERY”/“EMBROIDERY EDIT” MODE