Filter
Top Products
USING SENSOR FUNCTIONS WITH SEWING STITCH
B-80
g
Press to apply the first point of the
stitching width.
* The setting can also be applied by long touching an
adjustment area with the sensor pen.
h
With the sensor pen, touch the second
point for the stitching width.
→ The distance from the left reference line to the
touched position appears in the stitching width
setting screen.
→ The stitch preview on the upper left side of the
screen is updated according to the specified setting.
→ The guideline marker moves to the touched position
and flashes.
i
Press to apply the second point of the
stitching width.
* The setting can also be applied by long touching an
adjustment area with the sensor pen.
→ The needle moves to the specified position to start
sewing.
→ The stitch selection screen appears again, and the
stitch width and “L/R SHIFT” change according to
the settings specified with the sensor pen.
Note
• The following error message appears if the
area outside of the sensor pen touch range
is touched. Press , and then touch
within the sensor pen touch range.
Memo
• The position can be precisely adjusted by
touching the adjustment areas with the
sensor pen.
Note
• If the distance between the specified first
and second points is wider than the
maximum stitch width for the selected stitch
pattern, the second point cannot be
specified. Specify a location closer to the
first point.
• If the distance between the specified first
and second points is narrower than the
minimum stitch width for the selected stitch
pattern, the second point cannot be
specified. Specify a location further away
from the first point.
Note
• With multiple patterns that have been
combined, the specified stitching width is
applied to the pattern with the largest stitch
width. With patterns other than combined
patterns, the stitch width is adjusted to the
stitching width specified for the pattern with
the largest stitch width.
• With multiple patterns that have been
combined, the settings specified for the
stitch width and “L/R SHIFT” in the stitch
selection screen are for the first pattern to
be sewn. The value may differ from the
stitch width setting.
• With twin needle sewing, the stitching width
is specified with the left needle as the
reference.