Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - CHG RELAYS ? (COMMAND + 5 + 4)
Bosch Security Systems | 9/04 | 50410D 51
CHG RELAYS ? (COMMAND + 5 + 4)
Your security company may program relays for
automatic control and/or control from your keypad of
devices such as premises lighting or entry gates.
Contact them for further information regarding the use
of relays in your security system.
1. Ensure your keypad shows idle disarmed text.
2. Press the COMMAND key. The display shows
*System Command*
.
3. Press the 5 key and then the 4 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the CHG RELAYS ?>
prompt, press its adjacent soft key.
4. The command center display changes
*Change
Relay* Enter relay number:
Valid entries are 1 to 128, depending how the
system is configured.
Enter the relay number then press either the
Enter>
soft key or the ENTER button.
5. If the relay is valid and turned off, the display
changes to
Change Relay* Relay 123 is
currently off.
(123 is used as an example.)
Press the
Turn on>
soft key to turn on the relay.
6. If the relay is valid and turned on, the display
changes to
Change Relay* Relay 123 is
currently on.
(123 is used as an example.)
Press the
Turn off>
soft key to turn off the relay.
7. The display returns to the
*Change Relay* Enter
relay number:
Press the
<Exit
soft key to return to idle text.
CHG PASSCODES ? (COMMAND + 5 + 5)
Description
Use this function to change your personal passcode
without assistance from the security company.
Before you begin:
• Choose a new passcode three to six digits long. If
you choose a passcode with the same digit in
consecutive order (for example “33” in 334697),
take care when entering it.