Filter
Top Products
D1260/D1260B | Owner's Manual | Part II: System Commands - WALK TEST ? (COMMAND + 4 + 4)
26 Bosch Security Systems | 9/04 | 50410D
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the WALK TEST ?>
prompt, press its adjacent soft key.
Press ENTER.
4. The burglary bell sounds for 2 seconds. When the
display shows
### points remain to be tested
(### is the number of points) you can begin.
If you know the point number, you can
enter it by pressing its number key and
then the ENTER key
The display will change to show the point
that was entered. If the point is invalid the
message “Invalid Point” or “This is not a
valid walk point” appears.
Test each point by first opening and then closing
the door or window or other detection device.
Check the display after testing each point. For
interior points, walking past the device once is
sufficient. If any point does not test correctly,
contact your security company for service.
5. During the Walk Test you may want to see the
points that remain untested by pressing the
View
untested pts>
soft key.
The display shows
### points untested
.
Press the
Next Pt>
or
Prev Pt>
soft keys to see
information about specific points that have not yet
been tested.
6. Move through this list by pressing the
Next
Pt>
soft key.
The display changes to show the information for
that point.
Press the
Exit>
soft key to return to the
###
points remain to be tested
screen before
continuing with the walk test.
7. When all points have been tested,
0 points
remain to be tested
is displayed.
Press the
<Exit
soft key.
The display momentarily shows
All points have
been tested.
The displays then shows idle text.