Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - EXTEND CLOSING (COMMAND + 5 + 1)
Bosch Security Systems | 9/04 | 50410D 45
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the CHG DISPLAY ?>
prompt, press its adjacent soft key.
4. The display changes to show the display options:
•
Bright Display> -
Press to increase the LCD’s
backlit brightness. The backlight adjustment
will take effect after 20 seconds of inactivity.
•
Dim Display> -
Press to decrease the LCD’s
backlit brightness. The backlight adjustment
will take effect after 20 seconds of inactivity.
•
Time/Date Display> -
Press to continuously
show the time and date instead of idle text.
If your system is turned on (armed), you
cannot display the time.
To further adjust the LCD’s brightness,
the settings for the Bright Display> and
Dim Display> soft keys can be changed
by accessing the Service Manual (99 +
Enter).
EXTEND CLOSING (COMMAND + 5 + 1)
Your system may be programmed to expect you to
arm within a scheduled closing window, which is a
duration of time that is programmed by your alarm
company. Your system may also be programmed to
automatically arm at the end of the window.
COMMAND 51 lets you extend the scheduled closing
window time either prior to the closing window time or
during the closing window time. Use this function
when you expect to stay past the scheduled end of the
closing window. Your alarm company sets the length of
time prior to the start of the closing window in which
you are allowed to extend the closing window.
Close window is not currently active
displays during
the time when the keypad won’t allow the window to
be extended.
At the beginning of the closing window, the keypad
beeps and displays
Please Close Now
to remind you
to arm your system. It remains in the display until you
arm, the close window ends, or you extend closing.
The closing window can only be extended
once the window has started.
Alarm or trouble messages replace this message in the
event of an alarm or trouble condition.
Pressing the
Silence>
soft key will silence the beep
and clear the message for 10 minutes.
If the alarm or trouble condition clears before the end
of the close window
Please Close Now
message
returns to the keypad display.