Filter
Top Products
23
Bosch Security Systems 09/06 BLCC110U
Solution 64 User Guide
Comms > Periodic Test >
Send Test Report
MENU 5-9-0
This menu allows you to test the reporting functions of the
Solution 64 control panel by manually sending a ‘Test’ report to
the receiving party (i.e. security company monitoring station,
mobile telephone etc).
1. Enter [MENU] + [5] + [9] + [0].
The keypad will prompt that it is in the process of sending
a test report.
Comms testing in
progress. Please wait..
To Go Back Press OK
If the test is successful, the keypad will prompt:
Communications Test
Successful
If the test is NOT successful, the keypad will prompt:
Test Report Failed
Please call for service
Press OK or MENU
2. Press [OK] or [MENU] to exit.
Devices and Optional Modules
Programming options in this section relate to the keypads and
other devices which may be connected to your alarm system. Your
installer will advise you on the exact makeup and configuration
of your system.
Devices > Commands >
LAN Status
MENU 6-0-0
This option provides a listing of all of the devices and modules
connected to your system. Using this option it is poosible to view
the voltage, temperature and other information about each of
the modules.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [0].
Kp001 Keypad 001
Kp002 Keypad 002
Ox001 OutputX 001
Press OK or MENU
2. Use the [
↑] and [↓] keys to select the device that you want
to view, then press [OK] to select.
3. The display will show each parameter for the device one
at a time on the third line of the screen.
Keypad 001 Kp001
Graphic + Prox V1.01
Volts = 13.87
Press OK or MENU
4. Press [OK] or [MENU] to exit.
Devices > Keypads >
Volume
MENU 6-1-0
This menu allows you to adjust the volume of the keypad’s buzzer.
Each keypad will need to have their volume adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [1] + [0].
The keypad will display:
L
Keypad 001 Volume
Press
SAVE
OK
to
H
2. Use the [←] and [→] keys or use the [↑] and [↓] keys to
increase or decrease the volume of the keypad buzzer
until the desired volume has been reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Keypads >
Contrast
MENU 6-1-1
This menu allows you to adjust the contrast of the keypad’s LCD
display. Each keypad can have their display adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [1] + [1].
The keypad will display the contrast screen.
L
Keypad 001 Contrast
Press
SAVE
OK
to
H
2. Use the [←] and [→] keys to adjust the bar until the
desired contrast is reached.
Press [OK] to save and exit, or press [MENU] to exit
without saving.
3.